ABB IRB 2600ID Product Manual page 293

Equipment
Other tools and procedures may be re-
quired. See references to these procedures
in the step-by-step instructions below.
Removing the stop pin, axis 1
Use this procedure to remove the stop pin axis 1.
1
2
3
Refitting the stop pin, axis 1
Use this procedure to refit the stop pin axis 1.
1
2
Product manual - IRB 2600
3HAC035504-001 Revision: AD
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
Remove the attachment screws securing
the bracket and stop pin.
Remove the bracket and stop pin.
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
Fit the two o-rings on the stop pin.
Note
The o-rings are not used when bracket (D)
is installed.
© Copyright 2009-2023 ABB. All rights reserved.
4.6.1 Replacing stop pin axis 1
Note
These procedures include references to the
tools required.
Note
See the figure in
• Location of stop pin axis 1 on
page 292
See the figure in
• Location of stop pin axis 1 on
page 292
Note
See the figure in
• Location of stop pin axis 1 on
page 292
Continues on next page
4 Repair
Continued
293