Changing The Oil, Axis-4 Gearbox - ABB IRB 2600ID Product Manual

3 Maintenance

3.4.6 Changing the oil, axis-4 gearbox

3.4.6 Changing the oil, axis-4 gearbox
Location of oil plugs
The axis-4 gearbox is located in the front of the upper armhouse.
The oil plug is shown in the figure.
The figure shows IRB 2600 Standard but the position of oil plug is the same on
IRB2600ID.
xx0900000311
A
Required equipment
Equipment
Lubricating oil
Oil collecting vessel
Plastic hose
Funnel
Standard toolkit
Continues on next page
174
Oil plug, for filling and draining
© Copyright 2009-2023 ABB. All rights reserved.
Note
Where to find information of the type of oil,
article number and the amount in the gear-
box, see section Type of lubrication in gear-
boxes on page 151
The capacity of the vessel must be sufficient
to take the complete amount of oil.
Used for venting the gearbox during draining.
A suitable hose would be a hose normally
used for compressed air.
Length: minimum 300 mm. Diameter: 5 mm.
xx1200000862
Content is defined in section
on page 452.
Product manual - IRB 2600
3HAC035504-001 Revision: AD
Standard tools