Siemens SINUMERIK 840D Diagnostics Manual page 94

1 Alarms
Reactions:
Remedy:
Program Continuation:
10252
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10253
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10254
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10255
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-94
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Press RESET.
Clear alarm with the RESET key. Restart part program.
[up to SW 3.x only] Channel %1 reorg sequence canceled
%1 = Channel number
Internal sequence error. REORG is not possible at present.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Press RESET.
Clear alarm with the RESET key. Restart part program.
[up to SW 3.x only] Channel %1 reorg sequence canceled
%1 = Channel number
Internal sequence error. REORG is not possible at present.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Press RESET.
Clear alarm with the RESET key. Restart part program.
[up to SW 3.x only] Channel %1 reorg sequence canceled
%1 = Channel number
Interpreter output negative acknowledgement for REORG.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Press RESET.
Clear alarm with the RESET key. Restart part program.
[up to SW 3.x only] Channel %1 reorg sequence canceled
%1 = Channel number
Internal sequence error. REORG is not possible at present.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Press RESET.
Clear alarm with the RESET key. Restart part program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04