Siemens SINUMERIK 840D Diagnostics Manual page 448

1 Alarms
61340
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61341
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61342
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61343
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-448
Channel %1 block %2 Incorrect alarm number
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Internal error in measuring cycles.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Probe not calibrated in active plane
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE974, CYCLE977, CYCLE978,
CYCLE979.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Calibrate the probe prior to calling a cycle.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Entry of software version in GUD6 insufficient or format
incorrect
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Lower than measuring cycle software 6.2:_SI[1] in GUD6 has no value or a value < 3
Higher than measuring cycle software 6.3: Upgrade NCK software version.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 No tool available for specified tool identifier
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check name of tool identifier.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04