Siemens SINUMERIK 840D Diagnostics Manual page 454

1 Alarms
61365
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61366
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61367
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61368
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-454
Channel %1 block %2 Check circular feed
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE979.
Parameter _RF is <= 0.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Direction of rotation for tool measurement with rotating spin-
dle not specified in _CM[5]
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE971.
Permissible values for data field _CM[5] in GUD6 block are 3 (corresponds to M3) or 4
(corresponds to M4).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 The points P1 and P2 or P3 and P4 are identical
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE961.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify different positions for the relevant points of _SETV[0...7].
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 The straights determined by P1 and P2 or P3 and P4 do not
intersect
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE961.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify different positions for the relevant points of _SETV[0...7].
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04