Siemens SINUMERIK 840D Diagnostics Manual page 521

10.04
Remedy:
Program Continuation:
112350
Definitions:
Reactions:
Remedy:
Program Continuation:
112360
Definitions:
Reactions:
Remedy:
Program Continuation:
112400
Definitions:
Reactions:
Remedy:
Program Continuation:
112401
Definitions:
Reactions:
Remedy:
Program Continuation:
112402
Definitions:
Reactions:
Remedy:
Program Continuation:
112420
Definitions:
Reactions:
Remedy:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Approach reference point.
Clear alarm with the Delete key or NC START.
No swivel data set up.
There are no swivel data blocks.
- Alarm display.
Set up swivel data blocks (see /FBSP/, ShopMill Description of Functions)
Internal
The step was not accepted into the program sequence, as the program is running.
The program that you want to change is being executed in the operating mode "Machine
auto". You can only change programs that are not being executed in the operating mode
"Machine auto".
- Alarm display.
Stop the program run in the "Machine auto" operating mode.
Internal
Is not available in the tool management
The tool specified in the program does not exist.
- Alarm display.
The tool must be created before the data is saved.
Internal
Tool could not be created
When reading in the tool data, a tool could not be created.
- Alarm display.
Check tool management.
Internal
Work offsets: Error on writing
Data could not be written to the NC.
- Alarm display.
Should the alarm be displayed again after a new try, please contact the hotline of Sie-
mens AG, A&D MC.
Clear alarm with the Delete key or NC START.
Error during the inch/metric conversion! Check all data!
The switchover of the data for the inch/metric conversion was not completed.
This alarm can only appear in the event of hardware defects.
- NC Start disable in this channel.
- Alarm display.
The following data must be checked:
Display MD's:
MD9655: $MM_CMM_CYC_PECKING_DIST
MD9656: $MM_CMM_CYC_DRILL_RELEASE_DIST
MD9658: $MM_CMM_CYC_MIN_COUNT_PO_TO_RAD
MD9664: $MM_CMM_MAX_INP_FEED_P_MIN
1 Alarms
1-521