Siemens SINUMERIK 840D Diagnostics Manual page 533

10.04
Definitions:
Reactions:
Remedy:
Program Continuation:
129933
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
129934
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
142000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
142001
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
142002
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
--
- Alarm display.
Part program %2 can only be assigned to a channel in an NCU configured in NET-
NAMES.INI.
Internal
DAT: The configured channel (%1) for part program %2 in NCU %3 is invalid.
%1 = Channel number
%2 = Name of the part program
%3 = Name of the NCU according to NETNAMES.INI
--
- Alarm display.
Part program %2 can only be assigned to an existing channel of an NCU.
Internal
DAT: Part program %1 has been configured more than once.
%1 = Name of the part program
--
- Alarm display.
Part program %1 must not be used for time determination simultaneously in several chan-
nels.
Internal
Operator at the machine is waiting for support via remote diagnostics! %1 %2 %3
%4
%1 = IP address for existing Internet connection via modem
Will be triggered in "User Controlled" mode, if user uses "Request Support" function.
- Alarm display.
Acknowledge alarm
Internal
Operator at the machine is waiting for support via remote diagnostics! %1 %2 %3
%4
%1 = IP address for existing Internet connection via modem
Will be triggered in "User Controlled" mode, if user uses "Request Support" function.
- Alarm display.
Acknowledge alarm
Internal
Operator at the machine is waiting for support via remote diagnostics! %1 %2 %3
%4
%1 = IP address for existing Internet connection via modem
Will be triggered in "User Controlled" mode, if user uses "Request Support" function.
- Alarm display.
Acknowledge alarm
Internal
1 Alarms
1-533