Siemens SINUMERIK 840D Diagnostics Manual page 91

10.04
10223
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10224
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10225
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10226
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10227
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1: Command %2 is already occupied
%1 = Channel number
%2 = Event name
This channel has received a negative acknowledgment from the inter-channel communi-
cation because this command is already active or has not yet been terminated, e.g.:
INIT(x,"ncprog") but a program select request is already active for channel x.
- Alarm display.
This is an indication of possible discrepancies. The program continues if no acknowledg-
ment is called for.
Clear alarm with the Delete key or NC START.
[up to SW 3.x only] Channel %1: command denied
%1 = Channel number
The channel has received a command that cannot be executed, e.g.: activation of a pro-
gram test in automatic mode is only possible in the reset state.
- Alarm display.
Press RESET and activate the command again.
Clear alarm with the Delete key or NC START.
Channel %1: command denied
%1 = Channel number
The channel has received a command. The command cannot be executed.
- Alarm display.
Press RESET.
Clear alarm with the Delete key or NC START.
[up to SW 3.x only] Channel %1: reset aborted
%1 = Channel number
An error occurred during the reset, with the result that the sequence could not be contin-
ued.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Alarm display.
Press RESET again.
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
[up to SW 3.x only] Channel %1: command aborted
%1 = Channel number
An error occurred while a command was active, with the result that the sequence could
not be continued.
- Alarm display.
Activate the command again.
Clear alarm with the Delete key or NC START.
1 Alarms
1-91