Siemens SINUMERIK 840D Diagnostics Manual page 171

10.04
12720
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12722
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12724
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12726
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 program number for macro call (G65/G66) missing
%1 = Channel number
%2 = Block number, label
During macro call with G65/G66 no program number was defined. The program number
must be programmed with address "P".
- Correction block
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 multiple ISO_2/3 macro or cycle calls in the block
%1 = Channel number
%2 = Block number, label
A mixture of cycle and macro calls are programmed in a block, e.g. cycle calls with G81 -
G89 together with an M macro in the block or a G65/G66 macro call together with M mac-
ros in the block.
G05, G08, G22, G23, G27, G28, G29, G30, G50.1, G51.1, G72.1, G72.2 functions (ISO
mode) also execute subroutine calls. Only one macro or cycle call can appear in an NC
block.
- Correction block
- Interface signals are set.
- Alarm display.
Deactivate modal cycles or modal macro calls if one of the above mentioned G functions
has been programmed.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 no radius programmed for cylinder interpolation activation/
deactivation
%1 = Channel number
%2 = Block number, label
When programming G07.1 (cylinder interpolation TRACYL), no cylinder radius has been
programmed. Selection of the cylinder interpolation (TRACYL) with G07.1 C <cylinder
radius> deselect with G07.1 C0. For "C" the name of the rotary axis defined in the TRA-
CYL machine data has to be programmed.
- Correction block
- Interface signals are set.
- Alarm display.
G07.1 block, program the cylinder radius under the name of the rotary axis for the cylinder
interpolation.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal plane selection with parallel axes
%1 = Channel number
%2 = Block number, label
In a block with plane selection (G17 _ G19), a basic axis of the coordinate system must
not be programmed together with the parallel axis assigned to it.
- Correction block
- Interface signals are set.
- Alarm display.
1 Alarms
1-171