Siemens SINUMERIK 840D Diagnostics Manual page 64

1 Alarms
Reactions:
Remedy:
Program Continuation:
6401
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6402
Parameters:
Definitions:
1-64
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Error number 1: The memory reserved by machine data 12328
$MN_MM_CC_MD_MEM_SIZE has to be increased. If the error occurs while loading an
archive, then the machine data must be increased "manually". To do this, either Edit the
archive with 'arcedit' or Overwrite the MD in the MD picture and prevent the deletion of the
machine data when writing the archive (MMC: Set Ask_for_CFG_RESET.INI = 1 in
'dino.ini'). Also refer to: Upgrade instructions P6.x.
• Error number 2: Error in the combination or while reloading compile cycles: Do not acti-
vate compile cycle.
• Error number 3: Error in the combination or while reloading compile cycles: Do not acti-
vate compile cycle.
• Error number 4: Error in the compile cycle: Do not activate compile cycle.
• Error number 5: Error in the compile cycle: Do not activate compile cycle.
Switch control OFF - ON.
Channel %1 tool change not possible: Empty location for tool %2 Duplo no. %3 on
magazine %4 not available.
%1 = Channel ID
%2 = String (identifier)
%3 = Duplo number
%4 = Magazine number
The tool cannot be moved into the selected tool magazine. There is no appropriate loca-
tion for this tool. A suitable location is mainly determined by the status. The status must
indicate that this location is free, not disabled, not reserved and not co-occupied by a tool
that is too large. Furthermore, it is important that the type of tool matches the type of any
magazine location that may be free. (If, for example, all magazine locations are of the 'B'
type and these are all free and the tool is of type 'A', then this tool cannot be put into this
magazine).
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Check whether the magazine data have been defined correctly.
• Check whether there is still room in the magazine to add another tool; there may not be
due to operating procedures.
• Check whether a location type hierarchy is defined and whether it, for example, does not
allow insertion of a type 'A' tool in a free location with type 'B'.
Clear alarm with the RESET key. Restart part program.
Channel %1 tool change not possible. Magazine no. %2 not available
%1 = Channel ID
%2 = Magazine number
The desired tool change is not possible. The magazine with the specified number is not
available.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04