Siemens SINUMERIK 840D Diagnostics Manual page 476

1 Alarms
70014
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
70015
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
70016
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
70017
Parameters:
Definitions:
1-476
Channel %1 block %2 axis %3 reaches angle %4 on the drive
%1 = Channel number
%2 = Block number
%3 = Channel axis
%4 = Limit angle "+" or "-"
The indicated block includes a position on which the limit angles on the linear guides are
exceeded, see MD 62128 and 62129.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Modify parts program block
Clear alarm with the RESET key. Restart part program
Channel %1 axis %2 reaches angle %3 on platform
%1 = Channel number
%2 = Channel axis
%3 = Limit angle "+" or "-"
Cyclic monitoring of the cardanic angle on the platform detects a violation. The machine
axes are decelerated after having reached their max. acceleration. The specified contour
is left. %3 indicates the affected limit value.
• : MD 62126 was not reached
+ : MD 62127 was exceeded
- NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Select another traversing direction
Clear alarm with the RESET key. Restart part program
Channel %1 axis %2 reaches angle %3 on the drive
%1 = Channel number
%2 = Channel axis
%3 = Limit angle "+" or "-"
Cyclic monitoring of the angle between a rod and the associated linear guide detects a
violation. The machine axes are decelerated after having reached their max acceleration.
The specified contour is left. %3 indicates the affected limit value.
• : MD 62128 was not reached
+ : MD 62129 was exceeded
- NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Select another traversing direction
Clear alarm with the RESET key. Restart part program
Channel %1 OEM transformer: incorrect MD configuration, error code: %2
%1 = Channel number
%2 = Error code
On ramp-up the following error was found in the OEM transformation machine data:
Error code = 3
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04