Siemens SINUMERIK 840D Diagnostics Manual page 232

1 Alarms
14823
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14824
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14830
Parameters:
1-232
Channel %1 block %2 error on selection or deselection of tool monitoring
%1 = Channel number
%2 = Block number, label
On selecting tool monitoring with TMON, one of the following errors occurred:
• Selection does not refer to a grinding-specific tool (400-499).
• Selection refers to an invalid spindle number.
• An attempt has been made to select tool monitoring for a spindle that is already
assigned to another tool by TMON, GWPSON, CLGON or activation of tool length com-
pensation.
• An attempt has been made to select tool monitoring for the active tool although no tool
length compensation has been activated.
• Invalid parameter number for radius computation in $TC_TPG9.
The following values are valid:
3 for $TC_DP3 (length 1)
4 for $TC_DP4 (length 2)
5 for $TC_DP5 (length 3)
6 for $TC_DP6 (radius)
A grinding wheel radius equal to zero was specified.
On deselecting tool monitoring with TMOF, one of the following errors occurred:
• Deselection does not refer to a grinding-specific tool (400-499).
• An attempt has been made to deselect tool monitoring for the active tool although tool
length compensation is not active.
• The deselection refers to an invalid spindle number.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check TMON and TMOF command.
Check tool compensation data.
• $TC_DP1 : 400 - 499.
• $TC_TPG1: Spindle number.
• $TC_TPG8: Inclination angle for slope grinding wheel.
• $TC_TPG9: Parameter number for radius computation, e.g. 3 for $TC_GP3.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 conflict with GWPS
%1 = Channel number
%2 = Block number, label
The functions of constant grinding wheel surface speed GWPS and constant cutting
speed G96 S... have been activated at the same time for a spindle.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 wrong feed type selected
%1 = Channel number
%2 = Block number, label
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04