Siemens SINUMERIK 840D Diagnostics Manual page 518

1 Alarms
Remedy:
Program Continuation:
112057
Definitions:
Reactions:
Remedy:
Program Continuation:
112099
Definitions:
Reactions:
Remedy:
Program Continuation:
112100
Definitions:
Reactions:
Remedy:
Program Continuation:
112200
Definitions:
Reactions:
Remedy:
Program Continuation:
112201
Definitions:
Reactions:
Remedy:
Program Continuation:
112210
Definitions:
1-518
Check parameters in the residual material cycle.
Clear alarm with the Delete key or NC START.
Programmed helix violates contour
The starting point for helical insertion was so selected, that the helix violates the pro-
grammed contour.
The program can be started.
This alarm is only a warning.
- Alarm display.
Select another starting point; use a smaller helix radius.
Internal
System-error contour pocket
While the contour pocket was being calculated, an error occurred. The contour pocket
cannot be calculated.
The program cannot be started.
- Alarm display.
Make a note of the error text and contact the Siemens AG, A&D MC hotline.
Internal
Error during renumbering. Original state restored.
The softkey "Renumber" was pressed in the program editor. This caused an error during
serial numbering that damaged the program in the memory, making it necessary to reload
the initial program into the memory. The program was not renumbered.
- Alarm display.
Make room in the memory, e.g. by deleting an old program. Select "Renumber" again.
Internal
The contour is a step in the current program sequence. Machining not enabled
The contour is an element from a loaded program and cannot be deleted or renamed.
- Alarm display.
Remove the contour from the loaded program.
Internal
The contour is a step in the current automatic sequence. Machining not enabled
The contour is an element of a program loaded under "Machine auto" and cannot be
deleted or renamed.
After the program has been started, the integrated contours cannot be changed under
"Program" while the program is running.
- Alarm display.
Stop the program and load it under "Program". Remove the contour from the program.
Internal
Tool axis cannot be switched over. Insufficient NC memory.
If the tool axis is reselected, the NC program has to be generated again. Hereby the old
NC program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new
program.
The reselection of the tool axis was not carried out.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04