Siemens SINUMERIK 840D Diagnostics Manual page 410

1 Alarms
27255
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27256
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27299
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-410
PROFIsafe: F module %1, general error
%1 = PROFIsafe address
The specified PROFIsafe module signals an error. A more exact specification of the
error's cause cannot be made without further assistance.
This alarm is triggered for all types of PROFIsafe slaves.
With ET200S F modules, this error can only occur if there already is a channel error when
the cyclical communication between the F master and module is begun.
- Mode group not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Trigger a STOP D/E (settable via MD $MN_SPL_STOP_MODE) on all axes with safety
functionality.
Check wiring.
Clear alarm with the RESET key. Restart part program
PROFIsafe: Current cycle time %1 [ms]> parameterized cycle time
%1 = Current PROFIsafe communication cycle time
The current PROFIsafe communication cycle time is greater than the value set via MD
$MN_PROFISAFE_IPO_TIME_RATIO. The parameterized PROFIsafe communication
cycle time is continually exceeded on the PLC side.
- Mode group not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Trigger a STOP D/E (settable via MD $MN_SPL_STOP_MODE) on all axes with safety
functionality.
Adapt cycle time via MD $MN_PROFISAFE_IPO_TIME_RATIO.
The value displayed in parameter %1 has to be set at least.
The set cycle time affects the runtime load of the PLC module. This also has to be taken
into consideration when making the setting.
Clear alarm with the RESET key. Restart part program
PROFIsafe: Diagnostics %1 %2 %3 %4
%1 = Error code 1
%2 = Error code 2
%3 = Error code 3
%4 = Error code 4
Internal error in the NCK PROFIsafe implementation.
- Alarm display.
Make a note of the error text and contact Siemens A&D MC, Hotline
• Tel 0180 / 5050 - 222 (Germany)
• Fax 0180 / 5050 - 223
• Tel +49-180 / 5050 - 222 (International)
• Fax +49-180 / 5050 - 223
• Email techsupport@ad.siemens.de
Clear alarm with the Delete key or NC START.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04