Siemens SINUMERIK 840D Diagnostics Manual page 473

10.04
66000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
67000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
68000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
69000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
References: The current alarm text, the error description and the remedial measures for
the user cycle alarms can be found in the Programming Guide of the machine manufac-
turer.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Refer to the manual on user cycles.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
References: The current alarm text, the error description and the remedial measures for
the user cycle alarms can be found in the Programming Guide of the machine manufac-
turer.
- Alarm display.
Refer to the manual on user cycles.
Clear alarm with the Delete key or NC START.
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
References: The current alarm text, the error description and the remedial measures for
the user cycle alarms can be found in the Programming Guide of the machine manufac-
turer.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Refer to the manual on user cycles.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
References: The current alarm text, the error description and the remedial measures for
the user cycle alarms can be found in the Programming Guide of the machine manufac-
turer.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Refer to the manual on user cycles.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-473