Siemens SINUMERIK 840D Diagnostics Manual page 35

10.04
Reactions:
Remedy:
Program Continuation:
4027
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4028
Definitions:
Reactions:
Remedy:
Program Continuation:
4029
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4030
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- NC not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct and complete the logical axis assignments. Check machine data
MC_AXCONF_MACHAX_USED and MN_AXCONF_LOGIC_MACHAX_TAB.
Switch control OFF - ON.
Caution: MD %1 was also changed for the other axes of axis container %2
%1 = String: MD identifier
%2 = Axis container number
Message to the user indicating that the machine data change for the axis was also per-
formed for all other axes in the same container.
- Alarm display.
None
Clear alarm with the Delete key or NC START.
Attention! The axial MDs of the axes of the axis containers were matched.
Note for the user, that the machine data of the axis were matched in the axis containers.
- Alarm display.
None
Clear alarm with the RESET key. Restart part program
Caution: the axial MDs in axis container %1 will be matched on the next power-up
%1 = Axis container number
Message to the user indicating that the machine data of the axes in the axis container will
be matched on the next power-up. An axis container allows axes to be exchanged
between channels and NCUs. To ensure that no conflicts arise, the axes within the same
axis container must have a similar behavior. The first axis in the axis container determines
which machine data have to be the same for the other axis in the axis container.
- Alarm display.
None
Clear alarm with the Delete key or NC START.
Channel %1 axis identifier missing in machine data %2[%3]
%1 = Channel number
%2 = String: MD identifier
%3 = Index: MD array
An axis identifier is expected for the displayed MD in accordance with the axis configura-
tion in the MD 20070 AXCONF_MACHAX_USED and 20050
AXCONF_GEOAX_ASSIGN_TAB.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
1 Alarms
1-35