Siemens SINUMERIK 840D Diagnostics Manual page 482

1 Alarms
75061
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75062
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75070
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75071
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75090
Parameters:
Definitions:
Reactions:
1-482
Channel %1 MD modification on active coupling axis %2
%1 = Channel number
%2 = Axis name
Machine data MD 63000 CC_MASTER_AXIS has been changed when the coupling was
active.
- Alarm display.
- NC Stop on alarm.
Reset machine data to its old value, switch off the coupling and then enter the new value.
Clear alarm with the RESET key. Restart part program
Channel %1 axes to be coupled are not in standstill axis %2
%1 = Channel number
%2 = Axis name
The CC_Master and/or CC_Slave axes were not at standstill when the coupling was
switched on.
- Alarm display.
- NC Stop on alarm.
Input G601 for path axes or program a stop preprocessor (STOPRE) before coupling with
CC_COPON.
Clear alarm with the RESET key. Restart part program
Channel %1 wrong machine data for collision protection axis %2
%1 = Channel number
%2 = Axis name
Incorrect machine data for collision protection.
- Interpreter stop
- Alarm display.
Correct machine data. The axes must be either both rotary axes or both linear axes!
Clear alarm with the RESET key. Restart part program
Channel %1 collision monitoring axis %2
%1 = Channel number
%2 = Axis name
Collision monitor has responded.
- Alarm display.
- NC Stop on alarm.
Traverse the axis out of the danger area in manual mode.
Clear alarm with the RESET key. Restart part program
Axis %1 stopped by external process monitoring system
%1 = Axis number
An external process monitoring system has stopped the axis, as tool breakage is to be
expected or has already occured.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04