Siemens SINUMERIK 840D Diagnostics Manual page 75

10.04
Definitions:
Reactions:
Remedy:
Program Continuation:
6453
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6454
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6455
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
The desired tool change is not possible. The toolholder/spindle number has not been
defined.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check whether the toolholder number/spindle number and the magazine data have been
defined correctly. (See system variables $TC_MPP1, $TC_MPP5 of the buffer magazine)
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool change not possible. No assignment between tool-
holder/spindle no. = %3 and buffer magazine location %4
%1 = Channel ID
%2 = Block number, label
%3 = Spindle no.
%4 = Location no.
The desired tool change is not possible. No relation has been defined between the tool-
holder/spindle number and the buffer magazine location (Location No.)
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Check whether the magazine data ($TC_MLSR) have been defined correctly.
• Check whether the alarm-causing program command _ e.g. TCI _ has been pro-
grammed correctly.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool change not possible. No distance relation available.
%1 = Channel ID
%2 = Block number, label
The desired tool change is not possible. Neither the spindle nor the buffer magazine loca-
tion have a distance relation.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Check whether the magazine data ($TC_MDP2) have been defined correctly.
• Check whether the alarm-causing program command _ e.g. TCI _ has been pro-
grammed correctly.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool change not possible. Magazine location no. %3 not avail-
able in magazine %4
%1 = Channel ID
%2 = Block number, label
%3 = Magazine location number
%4 = Magazine number
The desired tool change is not possible. The indicated magazine location is not available
in the indicated magazine.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
1 Alarms
1-75