Siemens SINUMERIK 840D Diagnostics Manual page 530

1 Alarms
Remedy:
Program Continuation:
129901
Definitions:
Reactions:
Remedy:
Program Continuation:
129902
Definitions:
Reactions:
Remedy:
Program Continuation:
129903
Definitions:
Reactions:
Remedy:
Program Continuation:
129904
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
129905
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
129906
Parameters:
Definitions:
1-530
If the drive shall be backed up as well, it must be enabled. If the note shall not be dis-
played again, set the drive to "0" in machine data 30240 ENC_TYPE and 30130
CTRLOUT_TYPE.
Internal
Time determination is being initialized. Please wait ...
This indicates that the time determination is being initialized and that the operator shall
not yet press NC Start or execute other operator actions.
- Alarm display.
Not necessary. After completion of the initialization, the dialog box will be faded out again
automatically.
Internal
Recorded data are being processed. Please wait ...
This indicates that data recorded by time determination are currently processed and that
the operator shall not yet press NC Start or execute other operating actions.
- Alarm display.
Not necessary. After completion of the initialization, the dialog box will be faded out again
automatically.
Internal
Time determination is active.
This indicates that time determination is enabled and that the user can press NC Start.
- Alarm display.
Not necessary. As soon as all channels viewed for time determination are in Reset again,
this message will be cancelled automatically.
Internal
%1: Current NCK Version %2 is too low for time measurement. Version 500000 or
higher will be required.
%1 = Name of the NCU according to NETNAMES.INI
%2 = Current NCU version
--
- Alarm display.
Upgrade or replace the relevant NCU for the required software version in order to use the
time determination.
Internal
%1: Unable to determine the NCK version for time measurement.
%1 = Name of the NCU according to NETNAMES.INI
--
- Alarm display.
Connect to the NCU and restart the PCU if required.
Internal
%1: Unable to determine the number of channels.
%1 = Name of the NCU according to NETNAMES.INI
--
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04