Siemens SINUMERIK 840D Diagnostics Manual page 100

1 Alarms
10630
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10631
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10640
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10650
Parameters:
Definitions:
1-100
Channel %1 block %2 axis %3 at working area limit %4
%1 = Channel number
%2 = Block number, label
%3 = Axis, spindle number
%4 = String ( + or - )
The specified axis violates the working area limitation. This is recognized only in the main
run either because the minimum axis values could not be measured before the transfor-
mation or because there is a motion overlay.
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Program other motion or do not perform overlaid motion.
Clear alarm with the RESET key. Restart part program.
Channel %1 axis %2 rests at working area limit %3
%1 = Channel number
%2 = Axis, spindle
%3 = String ( + or - )
The specified axis reaches the working area limitation in JOG mode.
- Alarm display.
Setting data: Check 43420 WORKAREA_LIMIT_PLUS and 43430
WORKAREA_LIMIT_MINUS for the working area limitation.
Alarm display showing cause of alarm disappears. No further operator action necessary.
[up to SW 3.x only] Channel %1 block %3 spindle %2 cannot stop during gear
change
%1 = Channel number
%2 = Spindle number
%3 = Block number, label
The spindle is in the oscillating mode for a gear change and is waiting for the PLC
acknowledgement stating that the gear change has taken place (interface signal: Gear
has changed DB 31 - 48, DBX 16.3). During this phase spindle stop is not possible, initi-
ated by Reset (DB 21 - 28, DBX 7.7) or NC Stop axes plus spindle (DB 21 - 28, DBX 7.4).
- Alarm display.
No remedial measures are necessary. The spindle-specific interface signal Spindle reset
(DB 31 - 48, DBX 2.2) cancels the oscillation mode.
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 axis %2 incorrect gantry machine data, error code %3
%1 = Channel number
%2 = Axis
%3 = Error no.
An incorrect value was entered in the gantry-specific axial machine data. Further informa-
tion can be derived from the error number.
• Error no. = 1 => either an incorrect gantry unit has been entered or the designation of
the following axis is incorrect.
• Error no. = 2 => master axis has been specified more than once.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04