Siemens SINUMERIK 840D Diagnostics Manual page 210

1 Alarms
14420
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14430
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14432
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14434
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-210
Channel %1 block %2 index axis %3 frame not allowed
%1 = Channel number
%2 = Block number, label
%3 = Axis
The axis is to be traversed as an indexing axis, but a frame is active. This is not allowed
by machine data FRAME_FOR_CORRPOS_NOTALLOWED.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Modify part program.
Change machine data CORR_OR_AXIS_NOT_ALLOWED.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tangential axis %3 must not be traversed as POS axis
%1 = Channel number
%2 = Block number, label
%3 = Axis name
A tangentially followed-up axis cannot be traversed as positioning axis.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Change part program and delete active tangential control with TANGDEL.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 rounding length for tangential axis %3 is zero.
%1 = Channel number
%2 = Block number, label
%3 = Axis name
For a tangential axis that is coupled during preparation, a rounding length must be indi-
cated with TANGON() on activating the tangential control, or possibly occurring disconti-
nuities of the tangential axis cannot be smoothed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 rel. lift-off path for tangential axis %3 is invalid
%1 = Channel number
%2 = Block number, label
%3 = Axis name
Factor r as programmed on TLIFT for the relative lift-off path must be within range 0 =< r <
1.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04