Siemens SINUMERIK 840D Diagnostics Manual page 464

1 Alarms
Reactions:
Remedy:
Program Continuation:
61803
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61804
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61805
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61806
Parameters:
Definitions:
1-464
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2 programmed axis not present
%1 = Channel number
%2 = Block number, label
The programmed axis is not in the system.
Alarm triggered by following cycles: CYCLE83, CYCLE84, CYCLE840.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check parameter _AXN.
Check MD20050-20080.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Progr. position exceeds reference point
%1 = Channel number
%2 = Block number, label
The programmed intermediate position or actual position is behind the reference point.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Internal
Channel %1 block %2: The value is absolutely and incrementally programmed
%1 = Channel number
%2 = Block number, label
The programmed intermediate position is both absolutely as well as incrementally pro-
grammed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Internal
Channel %1 block %2: Incorrect axis assignment
%1 = Channel number
%2 = Block number, label
The axis-assignment sequence is wrong.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04