Siemens SINUMERIK 840D Diagnostics Manual page 529

10.04
120307
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
120308
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
120309
Definitions:
Reactions:
Remedy:
Program Continuation:
120310
Definitions:
Reactions:
Remedy:
Program Continuation:
129900
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
The file %1 cannot be opened for the editor because it is selected in channel %2 for
execution from external sources.
%1 = Program name with path
%2 = Channel number
--
- Alarm display.
A different program on the NCU or for execution from external sources has to be selected.
The alarm disappears automatically as soon as a program is edited or simulated in the
program area.
The alarm can also be acknowledged manually via diagnostics.
Internal
In the event of an emergency stop, the program %1 can only be changed in the
machine/program correction area.
%1 = Program name with path
--
- Alarm display.
Switch to the machine area and change the program with the program correction function.
The alarm disappears automatically as soon as a program is edited or simulated in the
program area.
The alarm can also be acknowledged manually via diagnostics.
Internal
The selection is not possible. Please close the simulation and repeat the selection.
The simulation is currently active in the program area.
A simultaneous editing is not possible.
- Alarm display.
Close the simulation and make the selection again.
The alarm disappears automatically as soon as a program is edited or simulated in the
program area.
The alarm can also be acknowledged manually via diagnostics.
Internal
The selection is not possible. Please wait for the pending action or terminate it,
then repeat the selection.
In the program area, programs are currently being copied, loaded or unloaded.
A simultaneous editing is not possible.
- Alarm display.
Wait until the action is completed or terminate the action via the softkey "Cancel" and then
repeat the selection.
The alarm disappears automatically as soon as a program is edited or simulated in the
program area.
The alarm can also be acknowledged manually via diagnostics.
Internal
Data of passive drives are not backed up!
This indicates that passive drives are not backed up as well when an upgrade is made.
- Alarm display.
1 Alarms
1-529