Siemens SINUMERIK 840D Diagnostics Manual page 430

1 Alarms
61188
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61191
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61192
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61193
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-430
Channel %1 block %2 no axis name for the 1st axis assigned -> Check installation
and start-up of the swivel cycle CYCLE800
%1 = Channel number
%2 = Block number, label
No axis name was specified for the 1st rotary axis. Alarm triggered by following cycles:
CYCLE800.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check installation and start-up of the swivel cycle CYCLE800.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 5-axis transformation not implemented
%1 = Channel number
%2 = Block number, label
The alarm is triggered by the following cycles: CYCLE832.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Second 5-axis transformation not implemented
%1 = Channel number
%2 = Block number, label
The alarm is triggered by the following cycles: CYCLE832.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Compressor option not implemented
%1 = Channel number
%2 = Block number, label
The alarm is triggered by the following cycles: CYCLE832.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04