Siemens SINUMERIK 840D Diagnostics Manual page 662

1 Alarms
410150
Definitions:
Reactions:
Remedy:
Program Continuation:
410151
Definitions:
Reactions:
Remedy:
Program Continuation:
411101
Definitions:
Reactions:
Remedy:
Program Continuation:
411501
Definitions:
Reactions:
Remedy:
Program Continuation:
411502
Definitions:
Reactions:
Remedy:
Program Continuation:
800000
Definitions:
Reactions:
Remedy:
Program Continuation:
810001
Definitions:
Reactions:
Remedy:
Program Continuation:
1-662
Area in M group decoder list is too large
Number of M groups in PLC too large.
- Alarm display.
Reduce the number of groups
Internal
Magazine data for tool management missing in the PLC
Magazine data are not available in the PLC. The start-up has not been completed,
although the option TOOLMAN has been activated.
- Alarm display.
Softkey Create PLC Data must be pressed during TOOLMAN start-up via MMC 103. Data
in data block DB4 must be set from DBB64 in MMC 100.
Internal
Impermissible Parameter Axis in FB11
Axis parameter not within the permissible range.
- Alarm display.
Use permissible axis number.
Internal
Incorrect version of FB 15, > general reset, do not transmit FB 15 from project
FB 15 does not match the basic program used.
- Alarm display.
General PLC reset. Use correct version of the basic program.
Internal
Incorrect basic PLC program version
FB 15 does not match the basic program used.
- Alarm display.
Load the basic program that matches the NCK version.
Internal
Error: HiGraph group no. %A graph no. %N status %Z
-
- Alarm display.
-
Internal
Error OB event, error analysis via STEP7 required
Reduced PLC error message. STEP7 is required for exact analysis.
- Alarm display.
Diagnose with STEP7.
Internal
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04