Siemens SINUMERIK 840D Diagnostics Manual page 208

1 Alarms
Reactions:
Remedy:
Program Continuation:
14410
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14411
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14412
Parameters:
1-208
• Special requirement with respect to the machine axis has not been fulfilled (e.g. rotary
axis is not a modulo axis) (-> modify machine data, restart).
TRACYL:
The programmed parameter is not allowed when transformation is selected.
TRAANG:
• The programmed parameter is not allowed when transformation is selected.
• Parameterization via machine data has an error.
• Parameter is faulty (e.g. TRAANG: unfavorable angle value (-> modify machine data,
restart)
Persistent transformation:
• Machine data for persistent transformation are wrong (-> consider dependencies,
change machine data, restart)
Only with active "OEM transformation" compile cycle:
The axes included in the transformation must be referenced!
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Modify part program or
machine data.
Only with active "OEM transformation" compile cycle:
Reference the axes included in the transformation before selecting transformation.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 spline active at geometry axis changeover
%1 = Channel number
%2 = Block number, label
It is not allowed to change the assignment of geometry axes to channel axes in a spline
curve definition.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool radius compensation active at geometry axis
changeover
%1 = Channel number
%2 = Block number, label
It is not permissible to change the assignment of geometry axes to channel axes when
tool radius compensation is active.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 transformation active at geometry axis changeover
%1 = Channel number
%2 = Block number, label
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04