Siemens SINUMERIK 840D Diagnostics Manual page 301

10.04
Reactions:
Remedy:
Program Continuation:
17620
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17630
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17640
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17650
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Deselect the transformation with TRAFOOF ahead of time or remove the action from the
part program block
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 approaching fixed point for transformed axis %3 not possible
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
In the displayed block, an axis is programmed for the fixed point approach (G75) that is
involved in the active transformation. Fixed point approach is not performed with this axis!
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remove G75 instruction from the part program block or previously deselect transforma-
tion with TRAFOOF.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 referencing for transformed axis %3 not possible
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
In the displayed block, an axis is programmed for reference point approach (G74) that is
involved in the active transformation. Reference point approach is not performed with this
axis!
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remove G74 instruction, or the machine axes involved in transformation, from the part
program block or previously deselect the transformation with TRAFOOF.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 spindle operation for transformed axis %3 not possible
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The axis programmed for the spindle operation is involved in the current transformation as
geometry axis. This is not allowed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
First switch off the transformation function.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 machine axis %3 not programmable
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
1 Alarms
1-301