Siemens SINUMERIK 840D Diagnostics Manual page 517

10.04
Remedy:
Program Continuation:
111902
Definitions:
Reactions:
Remedy:
Program Continuation:
111904
Definitions:
Reactions:
Remedy:
Program Continuation:
112045
Definitions:
Reactions:
Remedy:
Program Continuation:
112046
Definitions:
Reactions:
Remedy:
Program Continuation:
112052
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Terminate machining. Reload the Easystep sequence and change it correspondingly.
Internal
Start only with valid reference point
The axes have no valid reference point.
- Alarm display.
Reference all axes.
Internal
4. Axis not configured, i.e., no driven tool possible
4. The axis is not configured, i.e., no driven tool is possible.
- Alarm display.
4. Create an axis. Hereby, the following machine data has to be changed:
Channel-specific 20070 $MC_AXCONF_MACHAX_USED [3]=4
Axis-specific for the 4th axis.
30300 $MA_IS_ROT_AX=1
30310 $MA_ROT_IS_MODULO=1
30320 $MA_DISPLAY_IS_ MODULO=1
30350 $MA_SIMU_AX_VDI_OUTPUT=1
35000 $MA_SPIND_ASSIGN_TO_MACHAX=2
Internal
Several insertion points required
Several insertion points are required for machining the contour pocket. The machining
breaks up into several individual machinings.
The program can be started.
This alarm is only a warning.
Residual material will remain.
- Alarm display.
By using a smaller milling cutter, the machining could be done with an insertion point.
Internal
Main contour cannot be bypassed
The pocket contour cannot be bypassed with the specified milling cutter.
Residual material will remain.
The program can be started.
This alarm is only a warning.
- Alarm display.
By using a smaller milling cutter, the pocket contour could be bypassed.
Internal
No residual material existing
No residual material has been determined.
- Alarm display.
1 Alarms
1-517