Siemens SINUMERIK 840D Diagnostics Manual page 300

1 Alarms
Reactions:
Remedy:
Program Continuation:
17600
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17605
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17610
Parameters:
Definitions:
1-300
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Program the indexing axis position in the NC part program in accordance with the length
of the current position table, or add the required value to the position table and adjust the
length of the list.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 preset on transformed axis %3 not possible
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The displayed axis is involved in the current transformation. This means that is it not pos-
sible to set the actual value memory (preset) for this axis.
Example:
Machine axis A should be set to the new actual value A 100 at the absolute position A
300.
:
N100 G90 G00 A=300
N101 PRESETON A=100
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Avoid preset actual value memory for axes which are participating in a transformation or
deselect the transformation with the keyword TRAFOOF.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 transformation active: inhibits rotation of axis con-
tainer
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The programmed axis/spindle is active in a transformation and the axis container cannot
be rotated for this reason.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program. Deactivate the transformation for this axis/spindle before rotating the
axis container or perform the axis container rotation later.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 involved in the transformation, action cannot be car-
ried out
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The axis is involved in the active transformation. It can therefore not execute the
demanded action, traversing as positioning axis, enable for axis replacement.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04