Siemens SINUMERIK 840D Diagnostics Manual page 230

1 Alarms
Remedy:
Program Continuation:
14812
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14815
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14820
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14821
Parameters:
Definitions:
1-230
Adjust the value range in accordance with the Programming Guide. Values of 1 ... 200%
are allowed.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 SOFTA not available for axis %3
%1 = Channel number
%2 = Block number, label
%3 = Axis
SOFT is to be set as type of motion control for an axis. This is not possible because a
bent acceleration characteristic has been selected for this axis via machine data.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program or machine data.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative thread lead change programmed
%1 = Channel number
%2 = Block number, label
A negative thread lead change has been programmed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct the value assignment. The programmed F value should be greater than zero.
Zero is allowed but has no effect.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative value for maximum spindle speed programmed with
constant cutting speed
%1 = Channel number
%2 = Block number, label
For the function "Constant cutting speed G96" a maximum spindle speed can be pro-
grammed with the keyword LIMS=.... The values are in the range 0.1 - 999 999.9 [rev/
min].
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program the maximum spindle speed for the constant cutting speed within the limits given
above. The keyword LIMS is modal and can either be placed in front of or within the block
that selects the constant cutting speed.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 error in selection or deselection of GWPS
%1 = Channel number
%2 = Block number, label
On selecting grinding wheel surface speed programming with GWPSON, one of the fol-
lowing errors occurred:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04