Siemens SINUMERIK 840D Diagnostics Manual page 200

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
14180
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14185
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14190
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-200
If tool compensation (G43/G44) is activated in language mode ISO_2, the linear type of
interpolation must be active.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 H number %3 is not defined
%1 = Channel number
%2 = Block number, label
%3 = H number of ISO mode
The specified H number is not assigned to a tool (ISO_2).
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 D number %3 is not defined
%1 = Channel number
%2 = Block number, label
%3 = D number of ISO mode
The specified D number is not assigned to a tool (language mode ISO_2).
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 H number with G49
%1 = Channel number
%2 = Block number, label
G49 (select tool length compensation) and an H word not equal to H0 have been pro-
grammed simultaneously.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04