Siemens SINUMERIK 840D Diagnostics Manual page 291

10.04
Remedy:
Program Continuation:
17183
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17188
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17189
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Access the total offset memory with $TC_SCP*, $TC_ECP*, check the total offset selec-
tion DLx or tool selection Ty or offset selection Dz.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 H number already available in T no.= %3, D no.= %4
%1 = Channel number
%2 = Block number, label
%3 = T number
%4 = D number
Each H number (except for H=0) must be assigned in a TO unit only once.
The indicated edge already has the H number.
If the H number shall be assigned more than once, machine date 10890, bit 3 must be set
= 1.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Change program:
• Select different H number
Clear alarm with NC START or RESET key and continue the program.
Channel %1 D number %2 defined in tool T no. %3 and %4
%1 = Channel number
%2 = Offset number D
%3 = T number of first tool
%4 = T number of second tool
The specified D number %2 in the TO unit of channel %1 is not unique. The specified T
numbers %3 and %4 each have an offset with number %2. If tool management is active:
The specified T numbers belong to tool groups with different names.
- Interface signals are set.
- Alarm display.
1. Ensure that the D numbers within the TO unit are unique.
2. If unique numbering is not necessary for subsequent operations, do not use the com-
mand.
Clear alarm with the Delete key or NC START.
Channel %1 D number %2 of tools defined on magazine/location %3 and %4
%1 = Channel number
%2 = Offset number D
%3 = Magazine/location number of first tool, '/' as separator
%4 = Magazine/location number of second tool, '/' as separator
The specified D number %2 in the TO unit of channel %1 is not unique. The specified T
numbers %3 and %4 each have an offset with number %2.
If tool management is active:
The specified T numbers belong to tool groups with different names.
- Interface signals are set.
- Alarm display.
1 Alarms
1-291