Siemens SINUMERIK 840D Diagnostics Manual page 121

10.04
Reactions:
Remedy:
Program Continuation:
10780
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10781
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10782
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
• Continue machining with CANCEL and Start.
• Modify part program.
• Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 impermissible change of a turning or grinding tool with
active tool radius compensation
%1 = Channel number
%2 = Block number, label
A tool change on which the edge offset (difference between edge center and edge refer-
ence point) changes, is only permissible in straight and polynomial blocks.
It is impermissible in circular blocks, involute blocks and in blocks including rational poly-
nomials with maximum permissible numerator and denominator degrees.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
• Continue machining with CANCEL and Start.
• Modify part program.
• Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal orientation of involute with tool radius compensation
%1 = Channel number
%2 = Block number, label
Tool radius compensation is possible for involutes only if the compensation plane
matches the involute plane.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal curve type with tool radius compensation
%1 = Channel number
%2 = Block number, label
This alarm occurs, if an attempt is made to apply the tool radius compensation to a curve
type for which this function is not implemented. The only cause at present: Involute with
3D tool radius compensation.
1 Alarms
1-121