Siemens SINUMERIK 840D Diagnostics Manual page 501

10.04
104012
Definitions:
Remedy:
Program Continuation:
104014
Definitions:
Remedy:
Program Continuation:
104015
Definitions:
Remedy:
Program Continuation:
104016
Definitions:
Remedy:
Program Continuation:
104018
Definitions:
Remedy:
Program Continuation:
104019
Definitions:
Remedy:
Program Continuation:
104020
Definitions:
Remedy:
Program Continuation:
104023
Definitions:
Remedy:
Program Continuation:
104024
Definitions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
No master spindle available
No master spindle was configured.
Configure a master spindle via the machine data.
Internal
Incorrect entry
The entered value is impermissible, e.g., it lies outside the input limits.
Please observe the value range.
Internal
Number of parameters per cutting edge is zero
The number of parameters per cutting edge was not configured.
Configure the number of parameters per cutting edge via the machine data.
Internal
No spindle available
No spindle was configured.
Configure a spindle via the machine data.
Internal
Tool not available
The specified tool does not exist.
--
Internal
Tool type not available
The specified tool type does not exist.
Specify a valid tool type.
Internal
No empty location found
There is no empty location with the specified search parameters.
Correct search parameters.
Internal
Error during tool loading
An error occurred while a tool was being loaded; the procedure has been aborted.
Check loader.
Internal
Error during tool unloading
An error occurred while a tool was being unloaded; the procedure has been aborted.
Check unloader.
Internal
1 Alarms
1-501