Siemens SINUMERIK 840D Diagnostics Manual page 290

1 Alarms
Reactions:
Remedy:
Program Continuation:
17180
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17181
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17182
Parameters:
Definitions:
Reactions:
1-290
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal D number
%1 = Channel number
%2 = Block number, label
In the displayed block, access is made to a D number that is not defined and therefore is
not available.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check tool call in the NC parts program:
• Correct tool correction number D programmed? If no D number is specified with the tool
change command, then the D number set by machine data
$MC_CUTTING_EDGE_DEFAULT will be active automatically. It is D1 by default.
• Tool parameters (tool type, length,...) defined? The dimensions of the tool edge must
have been entered previously either through the operator panel or through a tool data file
in NCK.
Description of the system variables $TC_DPx[t, d] as included in a tool data file.
x ... Correction parameter number P
t ... Associated tool number T
d ... Tool correction number D
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 T no.= %3, D no.= %4 not existing
%1 = Channel number
%2 = Block number, label
%3 = T number
%4 = D number
A programmed D number was not recognized by the NC. By default, the D number refers
to the specified T number. If the flat D number function is active, T= 1 is output.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
If the program is incorrect, remedy the error with a correction block and continue the pro-
gram. If the data block is missing, download a data block for the specified T/D values onto
the NCK (via MMC with overstore) and continue the program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal sum correction number
%1 = Channel number
%2 = Block number, label
An attempt was made to access a non-defined total offset of the current tool edge.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04