Siemens SINUMERIK 840D Diagnostics Manual page 261

10.04
16777
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16778
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16779
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 coupling: following axis %3 for lead axis %4 not available
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
A coupling has been switched on in which the slave spindle/axis is currently not available.
Possible causes:
• The spindle/axis is active in the other channel.
• The spindle/axis has been accessed by the PLC and has not yet been released.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Put the master spindle/axis
with spindle/axis exchange into the necessary channel or release from the PLC.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 coupling: Ring coupling at following axis %3 and leading
axis %4 impermissible
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
A coupling has been switched on which results in a cyclic coupling, allowance being made
for further couplings. This cyclic coupling cannot be uniquely computed.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Configure link in accordance
with the MD or correct NC part program (channel MD: COUPLE_AXIS_n).
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 coupling: too many couplings for axis %3, see active leading
axis %4
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
More leading axes and spindles were defined for the specified axis/spindle than are
allowed. The last parameter to be specified is a leading value object/leading axis to which
the specified axis/spindle is already linked.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify part program.
Clear alarm with the RESET key. Restart part program.
1 Alarms
1-261