Siemens SINUMERIK 840D Diagnostics Manual page 442

1 Alarms
61258
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61259
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61260
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61261
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-442
Channel %1 block %2 Set parameter for counterspindle chuck in the spindle screen
%1 = Channel number
%2 = Block number, label
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify parameters "ZL1", "ZL2" and "ZL3" in screen form "Tools work offset" à ">" à
"Spindles".
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Program includes new machining steps from ShopMill %4
%1 = Channel number
%2 = Block number, label
%4 = ShopMill version
The program has been created with a ShopMill version that is higher than the existing
one.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Delete the machining step and reprogram machining if required.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Program includes new machining steps from ShopTurn %4
%1 = Channel number
%2 = Block number, label
%4 = ShopMill version
The program has been created with a ShopMill version that is higher than the existing
one.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Delete the machining step and reprogram machining if required.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Center offset too large
%1 = Channel number
%2 = Block number, label
The center offset of Center Boring is larger than permissible (see display MD 9862).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter smaller center offset.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04