Siemens SINUMERIK 840D Diagnostics Manual page 351

10.04
Reactions:
Remedy:
Program Continuation:
22067
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22068
Parameters:
Definitions:
Reactions:
Remedy:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department.
• Check that the specified tool is contained in the desired magazine, or program another
tool to be changed.
• Check whether the settings in machine data $MC_RESET_MODE_MASK,
$MC_START_MODE_MASK and the associated machine data
$MC_TOOL_RESET_NAME match the current definition data.
Clear alarm with the RESET key. Restart part program
Channel %1 tool management: tool change not possible since there is no tool avail-
able in tool group %2
%1 = Channel number
%2 = String (identifier)
The desired tool change is not possible. The specified tool group does not contain a tool
which is ready for use and could be used for tool change. It is possible that all of the tools
in question have been set to the 'Disabled' state by the tool monitoring function.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
• Ensure that the specified tool group contains a tool that is ready for use when tool
change is requested.
• This can be achieved, for example, by replacing disabled tools, or
• by releasing a disabled tool manually.
• Check whether the tool data are correctly defined. Have all intended tools in the group
been defined with the specified identifier and loaded?
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 tool management: no tool available in tool group %3
%1 = Channel number
%2 = Block number, label
%3 = String (identifier)
The specified tool group does not contain a tool which is ready for use and could be used
for tool change. It is possible that all of the tools in question have been set to the 'Dis-
abled' state by the tool monitoring function. The alarm can occur for example in conjunc-
tion with the alarm 14710 (error on INIT block generation). In this specific situation, NCK
attempts to replace the disabled tool located on the spindle with an available replacement
tool (which does not exist in this error condition).
The user must resolve this conflict, for example, by removing the tool located on the spin-
dle from the spindle by issuing a movement command (e.g. through MMC operation).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Ensure that the specified tool group contains a tool that is ready for use when tool
change is requested.
• This can be achieved, for example, by replacing disabled tools, or
• by releasing a disabled tool manually.
• If an alarm occurs on programming TCA: Has the duplo number been programmed >0?
1 Alarms
1-351