Siemens SINUMERIK 840D Diagnostics Manual page 298

1 Alarms
Program Continuation:
17270
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17500
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17501
Parameters:
1-298
• Machine data $MC_MM_NUM_SUMCORR has value -1: If an alarm occurs when writ-
ing one of the system variables $TC_ADPTx (x=1,2,3,T), the write operation must be
modified such that only adapter data which are already associated with the magazine
locations are written.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 call-by-reference: illegal variable
%1 = Channel number
%2 = Block number, label
Machine data and system variables must not be transferred as call-by-reference parame-
ters.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify NC program: Assign the value of the machine data or of the system variable to a
program-local variable and transfer this as parameter.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 is not an indexing axis
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
An indexing axis position has been programmed for an axis with the keywords CIC, CAC
or CDC that has not been defined as indexing axis in the machine data.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Remove programming
instruction for indexing axis positions (CIC, CAC, CDC) from the NC part program or
declare the relevant axis to be an indexing axis.
Indexing axis declaration:
Modify MD 30500: INDEX_AX_ASSIGN_POS_TAB
(indexing axis assignment)
The axis will become an indexing axis when an assignment to an indexing position table
was made in the stated MD. Two tables are possible (input value 1 or 2).
Modify MD 10900: INDEX_AX_LENGTH_POS_TAB_1
Modify MD 10920: INDEX_AX_LENGTH_POS_TAB_2
(Number of positions for 1st/2nd indexing axis)
Standard value: 0 Maximum value: 60
Modify MD 10910: INDEX_AX_POS_TAB_1 [n]
Modify MD 10930: INDEX_AX_POS_TAB_2 [n]
(Positions of the 1st indexing axis) The absolute axis positions are entered. (The list
length is defined via MD 10900).
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 indexing axis %3 with Hirth tool system is active
%1 = Channel number
%2 = Block number, label
%3 = Axis name
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04