Siemens SINUMERIK 840D Diagnostics Manual page 131

10.04
Definitions:
Reactions:
Remedy:
Program Continuation:
10914
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10930
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10931
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
The given feed profile is in part negative. However, negative path feed is not allowed. The
feed profile is ignored. The specified feed block end value is taken when traversing over
the entire block.
- Local alarm reaction.
- Alarm display.
No action is usually necessary. The alarm message indicates an error in the program-
ming, however, and this should be corrected.
Clear alarm with the Delete key or NC START.
Movement not possible while transformation active - in channel %1, block %2
%1 = Channel number
%2 = Block number, label
The machine kinematics does not allow the specified motion. Transformation-dependent
error causes can be in: TRANSMIT: A (circular) area exists around the pole, where posi-
tioning is not possible. The area is caused by the fact that the tool reference point cannot
be traversed as far as into the pole.
The area is defined by:
• the machine data ($MC_TRANSMIT_BASE_TOOL..)
• the active tool length compensation (see $TC_DP..). Whether the tool length compensa-
tion is included in the calculation depends on the working plane selected (see G17,..).
• The machine stops before the faulty block.
- Interpreter stop
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Modify part program. Change the incorrectly specified tool length compensation.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 interpolation type not allowed in stock removal contour
%1 = Channel number
%2 = Block number, label
The following types of interpolation are allowed in the contour program for stock removal:
G00, G01, G02, G03, CIP, CT
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
In the contour subroutine, program only path elements that consist of straight lines and
arcs.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 incorrect stock removal contour
%1 = Channel number
%2 = Block number, label
The following errors occurred in the subroutine for the contour during stock removal:
• Full circle
• Overlapping contour elements
• Wrong start position
1 Alarms
1-131