Siemens SINUMERIK 840D Diagnostics Manual page 206

1 Alarms
Reactions:
Remedy:
Program Continuation:
14400
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14401
Parameters:
Definitions:
Reactions:
1-206
3: Block with contour handwheel cannot be executed as the handwheel performs a DRF
movement
for this axis of the path
4: PLC axis with axial handwheel override cannot be started immediately as the hand-
wheel performs
a DRF movement for this axis
5: The axis is a reciprocating axis with axial handwheel override; the reciprocating move-
ment cannot be
started immediately as the handwheel performs a DRF movement for this axis
6: The DRF movement for this axis cannot be executed as an axial handwheel override is
active for
this axis with the handwheel
7: The DRF movement for this axis cannot be executed as a velocity override of the path
with
the handwheel is active and the axis belongs to the path
8: The DRF movement for this axis cannot be executed as the contour handwheel is
active with
this handwheel and the axis belongs to the path
9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with
handwheel
override that is active with this handwheel
10: The DRF movement for this axis cannot be executed as the axis is active as recipro-
cating axis
with handwheel override with this handwheel
- Alarm display.
Use the handwheel for one purpose at a time only.
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 block %2 tool radius compensation active at transformation switcho-
ver
%1 = Channel number
%2 = Block number, label
A change of transformation is not allowed when tool radius compensation is active.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Perform tool radius compensation in the NC part program with G40 (in a block with G00 or
G01) before performing a transformation change.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 transformation not available
%1 = Channel number
%2 = Block number, label
The required transformation is not available.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04