Siemens SINUMERIK 840D Diagnostics Manual page 461

10.04
Reactions:
Remedy:
Program Continuation:
61605
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61606
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61607
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61608
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Use a different tool or check the contour subroutine.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 contour incorrectly programmed
%1 = Channel number
%2 = Block number, label
Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76,
CYCLE77, CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 contour processing error
%1 = Channel number
%2 = Block number, label
Error detected with the contour preparation This alarm is always issued in connection with
an NCK alarm 10930...10934, 15800 or 15810. Alarm triggered by following cycle:
CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 starting point incorrectly programmed
%1 = Channel number
%2 = Block number, label
The starting point reached before the cycle call does not lie outside the rectangle
described by the contour subroutine. Alarm triggered by following cycle: CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 wrong cutting edge position programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE94, CYCLE96.
1 Alarms
1-461