Siemens SINUMERIK 840D Diagnostics Manual page 65

10.04
Reactions:
Remedy:
Program Continuation:
6403
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6404
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6405
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Check whether the magazine data have been defined correctly.
• Check whether the magazine is connected to the desired tool holder/spindle via a dis-
tance relation.
• The user PLC program may have sent wrong data to the NCK.
Clear alarm with the RESET key. Restart part program.
Channel %1 tool change not possible. Magazine location number %2 on magazine
%3 not available.
%1 = Channel ID
%2 = Magazine number
%3 = Magazine location number
The desired tool change is not possible. The specified magazine location is not contained
in the specified magazine.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check whether the magazine data have been defined correctly.
The user PLC program may have delivered incorrect data to the NCK.
Clear alarm with the RESET key. Restart part program.
Channel %1 tool change not possible. Tool %2 not available or not usable
%1 = Channel ID
%2 = String (identifier)
The desired tool change is not possible. The specified tool does not exist or cannot be
inserted.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Check whether the part program is written correctly.
• Check whether the tool data are correctly defined.
• Check whether there is a replacement tool which can be used for the specified tool.
Clear alarm with the RESET key. Restart part program.
Channel %1 command %2 has invalid PLC acknowledge parameter %3 - identifier
%4
%1 = Channel ID
%2 = Command no.
%3 = PLC acknowledge parameter
%4 = Error code
The specified command has been answered by PLC with an invalid acknowledgement in
the current combination. The following assignments are defined for "command no.":
1 Move tool, load or unload magazine
2 Prepare tool change
1 Alarms
1-65