Siemens SINUMERIK 840D Diagnostics Manual page 642

1 Alarms
Reactions:
Remedy:
Program Continuation:
380003
Parameters:
Definitions:
1-642
Client ID = 2: NCK
The following can be causes:
• Error in contents of SDB1000
• Corruption of parts of system program
• Hardware defect on NC component
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy for 1-11:
1. Check the control project (particularly SDB1000); check MD 11240; if a user-specific
SDB1000 is in use, load it again.
2. If the error still exists, save the data and restart the control system with the default val-
ues with which the system was supplied.
3. If the system starts up without an error, the user data should be loaded one step at a
time.
4. If the error still exists after startup with the default values, reboot from the PC card or
update the software.
5. If the error still exists, replace the hardware.
Remedy for 20-21:
1. Check/correct the PROFIBUS addresses of the connected slaves.
Remedy for 22
1. Check the SDB
• Check the telegram type and length
• Adjust the slot rooting with P978
2. Analyze the drive alarms
Remedy for 23-24
1. It is necessary to replace the software
Remedy for 25
1. Change the telegram type
2. Reduce the number of slots
3. Reduce the number of slaves
4. Create a new SDB
5. It is necessary to replace the software
If the error cannot be eliminated by this procedure, please make a note of the error text
and contact the control system manufacturer.
Switch control OFF - ON.
Profibus-DP: operating error, reason %1, parameter %2 %3 %4.
%1 = Cause of the error
%2 = Parameter 1
%3 = Parameter 2
%4 = Parameter 3
An operating error occurred on the PROFIBUS DP in cyclic mode.
Overview: Cause of the error, Par 1, Par 2, Par 3:
• 01 = unknown alarm, alarm class, logical address, --
• 02 = DPM cycle timeout, DPM actual value status, DPM setpoint value status, --
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04