Siemens SINUMERIK 840D Diagnostics Manual page 134

1 Alarms
Reactions:
Remedy:
Program Continuation:
10944
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10945
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10946
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-134
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct the part program and start it again.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 curve table %3: illegal transformation
%1 = Channel number
%2 = Block number, label
%3 = Number of curve table
It is impermissible to use a transformation in a curve table if the leading axis or following
axis programmed in CTABDEF is involved in the transformation. Exception: TRAANG.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct NC part program.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 curve table %3: illegal coupling of axes
%1 = Channel number
%2 = Block number, label
%3 = Number of curve table
It is not possible to program axis links for the leading axes and following axis programmed
in CTABDEF.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct NC part program.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 curve table %3: no contour defined
%1 = Channel number
%2 = Block number, label
%3 = Number of curve table
No movement for the leading axis was programmed between CTABDEF and CTABEND.
A curve table is not permitted without a contour.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct the part program and start it again.
Clear alarm with the RESET key. Restart part program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04