Siemens SINUMERIK 840D Diagnostics Manual page 256

1 Alarms
Reactions:
Remedy:
Program Continuation:
16710
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16715
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16720
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-256
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Use only the feed type G94 or G95 in the thread cutting functions.
After G33 and before G63, deselect the thread cutting function with G01.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 master spindle not programmed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A master spindle function has been programmed (G33, G331, G95, G96) but the speed or
the direction of rotation of the master spindle is missing.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Add S value or direction of rotation for the master spindle in the displayed block.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 axis %3 spindle not in standstill
%1 = Channel number
%2 = Block number, label
%3 = Spindle number
In the applied function (G74, reference point approach), the spindle must be stationary.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program M5 or SPOS/SPOSA in front of the defective block in the part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 thread lead is zero
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
No lead was programmed in a thread block with G33 (thread with constant lead) or G331
(rigid tapping).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
The thread lead must be programmed for the specified geometry axis under the associ-
ated interpolation parameters.
X -> I
Y -> J
Z -> K
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04