Siemens SINUMERIK 840D Diagnostics Manual page 260

1 Alarms
16772
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16774
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16776
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-260
Channel %1 block %2 axis %3 is the slave axis, the coupling is being opened
%1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
>The axis is active as a slave axis in a coupling. In the REF operation mode, the coupling
is opened. The alarm can be suppressed by means of machine data 11410
SUPPRESS_ALARM_MASK Bit29 = 1.
- Alarm display.
The coupling will be closed again after having exited the REF operation mode.
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 electronic gear EG: synchronization aborted for slave axis %2
%1 = Channel number
%2 = Axis name, spindle number
For the indicated axis, the synchronization procedure (EGONSYN or EGONSYNE) was
aborted.
There are several reasons for aborting the synchronization process:
- RESET
- End of program
- Axis goes to follow-up mode
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
If the synchronization process cannot be aborted, this can be achieved by specifying
block change criterion FINE in EGONSYN or EGONSYNE.
If the synchronization process abort is tolerable or intended, the alarm can be suppressed
by means of machine date 11410 SUPPRESS_ALARM_MASK Bit31 = 1.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 curve table %3 does not exist for axis %4
%1 = Channel number
%2 = Block number, label
%3 = Number of curve table
%4 = Axis name, spindle number
An attempt was made to couple axis %4 with curve table number %3, but no curve table
of this number exists.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify the NC part program so that the required curve table exists when axis link is to be
activated.
Clear alarm with the RESET key. Restart part program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04