Siemens SINUMERIK 840D Diagnostics Manual page 669

Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

03.04
No. 27
Explanation
Not allowed if
Remedy
No. 28
Explanation
Not allowed if
Remedy
No. 29
Explanation
Not allowed if
Remedy
No. 30
Explanation
Not allowed if
Remedy
No. 31
Explanation
Not allowed if
Remedy
No. 32
Explanation
Not allowed if
Remedy
No. 33
Explanation
Not allowed if
Remedy
No. 34
Explanation
Not allowed if
Remedy
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Start continuation of the selected process (JOG, reference point or digitizing) (VDI signal:
NC Start).
1. JOG motion is active.
2. An alarm reaction is pending, which prevents a start or forces braking.
-
> Execute condition for clearing alarm.
Start processing in the digitizing submode. (VDI signal: NC Start).
1. JOG motion is active.
2. An alarm reaction is pending, which prevents a start or forces braking.
3. Homing has not yet been performed.
-
> Execute condition for clearing alarm.
> Approach reference point.
Stop all axes (VDI signal: Stop All or with Reset key).
-
-
Perform a program stop (NC block: M0).
-
-
Stop the JOG motion. (VDI signal: NC Stop).
-
-
Stop digitizing (VDI signal: NC Stop).
-
-
Start the selected process (VDI signal: NC Start).
1. Process change is active (operating mode change, activate/deactivate digitizing/over-
store).
2. An alarm reaction is pending, which prevents a start or forces braking.
3. A process is running (NC program, block search, loading machine data).
-
> Execute condition for clearing alarm
-
Stop the active process (VDI signal: NC Stop).
-
-
1 Alarms
1-669

Advertisement

Table of Contents
loading

Table of Contents