Siemens SINUMERIK 840D Diagnostics Manual page 457

10.04
Remedy:
Program Continuation:
61404
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61405
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61406
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61407
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Call the SIEMENS hotline
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Internal cycle error on tool offset
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check the dependent tool specifications.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Tool environment in _TENV does not exist
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct the names or create this environment.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Check DL_NUMBER in _DLNUM
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Check the 6th number and higher of _KNUM
%1 = Channel number
%2 = Block number, label channel number
6th position of _KNUM includes invalid values.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
1 Alarms
1-457