Siemens SINUMERIK 840D Diagnostics Manual page 77

10.04
Remedy:
Program Continuation:
6550
Definitions:
Reactions:
Remedy:
Program Continuation:
6560
Definitions:
Reactions:
Remedy:
Program Continuation:
6570
Definitions:
Reactions:
Remedy:
Program Continuation:
6580
Definitions:
Reactions:
Remedy:
Program Continuation:
6600
Definitions:
Reactions:
Remedy:
Program Continuation:
6610
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
• Delete or unload directory (e.g. workpiece), or
• Increase $MM_NUM_DIR_IN_FILESYSTEM.
Clear alarm with the Delete key or NC START.
Too many subdirectories
The number of subdirectories in a directory of the NCK has reached the maximum limit.
- Alarm display.
Please inform the authorized personnel/service department.
• Delete or empty subdirectories in the respective directory, or
• Increase $MM_NUM_SUBDIR_PER_DIR.
Clear alarm with the Delete key or NC START.
Data format not allowed
An attempt was made to write impermissible data in an NCK file. This error can occur in
particular when the attempt was made to load binary data in the NCK as ASCII file.
The error can also occur during preprocessing of cycles (see
$MN_PREPROCESSING_LEVEL) if the NC block is very long. In this case, subdivide the
NC block.
- Alarm display.
Specify that the file concerned is a binary file (e.g. extension: .BIN).
Clear alarm with the Delete key or NC START.
NC memory full
The NC card file system of the NCK is full. The task cannot be executed. Too many sys-
tem files were created in the DRAM.
- Alarm display.
Start fewer "execute from external" processes.
Clear alarm with the Delete key or NC START.
NC memory full
The NC card file system of the NCK is full. The task cannot be executed. To many files
have been loaded
- Alarm display.
Delete or empty files (e.g. part programs).
Clear alarm with the Delete key or NC START.
NC card memory is full
The NC card file system of the NCK is full. No more data can be stored on the NC card.
- Alarm display.
Delete the data on the PCMCIA card.
Clear alarm with the Delete key or NC START.
Too many files open on NC card
Too many files are being accessed simultaneously on the NC card.
- Alarm display.
Repeat the action later.
Clear alarm with the Delete key or NC START.
1 Alarms
1-77